Yamaha CS1D Operating Manual page 359

9 Level meters
These level meters display the peak level of the signal
being output from the internal effect.
0
A
0 ATTENUATOR
These knobs adjust the dedicated attenuator for the
internal effect.
The range is –96 – 0 dB.
This attenuator is used to prevent the signal from
clipping after effect processing. If the signal clips at
the input meter, adjust the send level of the send
channel to lower the level.
A FILTER
These knobs adjust the cutoff frequency for the dedi-
cated filters (HPF/LPF) of the internal effect.
The range is as follows.
HPF ....................Thru (bypass), 21 Hz–8.00 kHz
LPF ......................50 Hz – 16.0 kHz, Thru (bypass)
This filter is applied to the signal before it is pro-
cessed by the effect. For some effect types, there is
no filter.
B Effect parameters
These parameters determine the effect.
The type of effect parameters will depend on the cur-
rently selected effect (3).
For details on the effect parameters, refer to "CS1D
Reference Manual (Appendices)".
C BALANCE
This knob adjust the balance between the original
(dry) sound and the effect (wet) sound.
A setting of 0(%) is only the original sound, and
100(%) is only the effect sound.
D ASSIGN
This button assigns the effect parameters to the
encoders of the MIX OUTPUT block, allowing you
to edit the parameters in realtime. For details on
operation, refer to Basic Operation p.130.
D
B
EFFECT functions
C
11