Matrix Channel Section - Yamaha CS1D Operating Manual

CS1D Reference Manual (Hardware)

MATRIX channel section

In this section you can set the on/off status and output level of MATRIX channels 1–24.
1 MATRIX [NAME] indicator
This displays the short name of the MATRIX chan-
nel.
The short name can be input in the display (OUT
PATCH function NAME screen, etc.).
2 MATRIX [ON] switch and LED
This is the on/off switch for the MATRIX channel.
(The LED will light when this is on.)
When this switch is off, no signal will be sent to the
channel of the output unit that is patched to the cor-
responding MATRIX channel.
3 MATRIX SAFE [RCL] LED
This LED will light if the MATRIX channel has been
set to Recall Safe (a state in which the channel is
unaffected by scene recall operations).
The parameters of a MATRIX channel for which this
LED is lit will not change when a scene memory is
recalled.
Recall Safe settings can be made in the SELECTED
OUTPUT CHANNEL block or display (SCENE
function RECALL SAFE screen).
4 MATRIX SAFE [MUTE] LED
This LED will light if the MATRIX channel has been
set to Mute Safe (a state in which the channel is unaf-
fected by mute group operations).
A MATRIX channel for which this LED is lit will not
be affected even if a mute group to which it belongs
is muted.
Mute Safe settings can be made in the SELECTED
OUTPUT CHANNEL block or display (OUT DCA/
MUTE function MUTE GROUP ASSIGN screen).
48
1
2
ON
5
PAIR
6
7
8
3
ON
4
6
9
5 MATRIX [PAIR] LED
This LED will light when two adjacent odd and even-
numbered MATRIX channels 1–24 are paired (i.e.,
MATRIX channels 1/2, 3/4, ...).
MATRIX channel pairing can be set or defeated from
the console by using the MATRIX [SEL] switches
(9), or in the display (MATRIX/ST function, etc.).
6 MATRIX [LEVEL/BAL] encoder and LEDs
This encoder sets the output level of the MATRIX
channel 1–24 (the level of the signal that is sent to the
output unit patched to that MATRIX channel)
The range is from –
mate current value is shown by the perimeter LEDs.
The LED at the mark will light to indicate nomi-
®
nal level (0 dB).
If two adjacent odd and even-numbered MATRIX
channels are paired, the right (even-numbered)
encoder will function as the MATRIX [LEVEL]
encoder to set the common output level of the two
channels, and the left (odd-numbered) encoder will
function as the MATRIX [BAL] encoder to set the
volume balance between the two channels.
In this case as well, the approximate current value is
shown by the perimeter LEDs. Of the LEDs around
the [BAL] encoder, the LED at the
to indicate that the left/right balance is equal.
– +10 dB, and the approxi-
mark will light
q