Checking The Operation Of An Output Unit; Preparations For Checking - Yamaha CS1D Operating Manual

Checking the operation of an output unit

This section explains the procedure for checking the operation of an output unit connected to the DSP1D-EX {DSP1D}
engine. The general procedure is as follows.
Connect an input source to an input unit
m m m m
Connect your monitor system to an output unit
m m m m
Turn on the power in the order of input unit
m m m m
Patch the input unit to an input channel
m m m m
Patch the output unit to the STEREO A channel
m m m m
Send the input channel signal to the STEREO bus
m m m m
Check whether the signal is output from the STEREO OUT A jacks

Preparations for checking

Before you begin checking the operation of an output unit, make sure that the following actions have been completed.
Connect the various components that are part of
the PM1D system ( p.6–13)
Use the indicators/LEDs of the input/output units
and the engine to verify that the components are
correctly connected to each other ( p.14–21)
Set the operation mode and the word clock master
as appropriate for the configuration of the PM1D
system that you are using ( p.22–29).
38
DSP1D-EX {DSP1D} engine CS1D console monitor system