Lcr - Yamaha CS1D Operating Manual

Output functions

LCR

[Function]
Make settings for LCR mode to allow three-channel playback, with a CENTER channel added to the L/R
channels of the STEREO bus. This function can be used only for MIX channels.
Console
In the LCD FUNCTION ACCESS
block, press the OUTPUT
[MATRIX/ST] switch (press repeat-
edly until the screen shown at the
right appears)
Display
MENU button OUTPUT
MATRIX/ST button LCR tab
[Screen functions]
2
1 CENTER BUS CONTROL
When this button is on, the STEREO B channel will
function as the CENTER channel.
By adding the CENTER channel to the L/R channels
of the STEREO A bus, you can implement three-
channel playback.
112
1
4 3
When this button is off, the CENTER channel sig-
nal will no longer be sent to STEREO B, meaning
that it will not be output externally. (The same LR
signal as STEREO A will be sent to STEREO B.)
However even when the CENTER BUS CONTROL
button is off, you can operate LCR pan for channels
in which LCR mode is turned on. (When you turn
the button on, the LCR setting will immediately
take effect.)
2 LCR (LCR mode on/off)
For each MIX channel, turn LCR mode on/off.
In the case of channels for which LCR mode is
turned on, the [PAN/BAL] encoder can be used to
simultaneously control the level of the L/R channels
and the CENTER channel if the [TO ST PAN] switch
(located in the SELECTED OUTPUT CHANNEL
output block of the CS1D top panel) is not turned
on.
Hint
On channels for which LCR mode on, rotating the
[PAN/BAL] encoder will cause the perimeter LEDs
to light as follows.