Yamaha CS1D Operating Manual page 245

7 ST IN [INS] LED
This LED will light if insertion is turned on for the
ST IN channel.
Insertion can be switched from the console in the
SELECTED INPUT CHANNEL block, or in the dis-
play (IN PATCH function INSERT/DIRECT POINT
screen).
8 ST IN [ø] (Phase) LED
This LED will light if the phase has been reversed for
the input signal of this ST IN channel.
The phase setting can be made from the console in
the SELECTED INPUT CHANNEL block, or in the
display (IN HA/INSERT function).
9 ST IN [A]/[B] LEDs
For a ST IN channel to which an AD card with swit-
chable A/B inputs has been patched, one of these
LEDs will light to indicate the currently selected
input jack (A/B).
For a ST IN channel to which a different type of card
has been patched, the LEDs will be dark.
You can switch between A/B input jacks in the
SELECTED INPUT CHANNEL block of the console,
or in the display (IN HA/INSERT function or IN CH
VIEW function).
Hint
This parameter can be set independently for left and
right channels.
0 ST IN [GAIN] encoder and LEDs
If an AD card with head amp is patched to this ST IN
channel, this encoder will adjust the input sensitivity
of the head amp. The range of levels is +10 dB — –68
dB.
The approximate current value is shown by the
perimeter LEDs.
Hint
This parameter can be set independently for left and
right channels.
A ST IN CLIP [L]/[R] LED
This LED will light when the input signal of the ST
IN channel clips. If this LED lights when an AD card
with head amp has been patched to this ST IN chan-
nel, use the ST IN [GAIN] encoder (0) to lower the
input sensitivity.
If this LED lights when an AD card without head
amp or a digital I/O card has been patched to this ST
IN channel, lower the output level of the sound
source connected to the corresponding card.
L CLIP
L
SEL
D
R
SEL
G
ON
B ST IN COMP [+]/[THR]/[–] LEDs
The LEDs indicate the operating status of the inter-
nal compressor. If the compressor is turned off, all
LEDs will be dark.
If the compressor is turned on, one of the LEDs will
light to indicate the currently selected type and status
of the compressor.
When the compressor type is COMP
COMP
Level
ATTACK
[–] [THR] [+]
When the compressor type is EXPANDER
EXPANDER
Level
ATTACK
[–] [THR] [+]
ST IN block
R
+
B
THR
-
COMP
+
C
THR
-
GATE
E
CLIP
6
12 F
18
30
60
Key-in signal
Output signal
RELEASE
Threshold level
Time
[THR] [–]
Key-in signal
Output signal
RELEASE
Threshold level
Time
[THR] [–]
15