Chapter 5. Basic Operation For Output Channels; About The Output Channels; Blocks Used To Control The Output Channels - Yamaha CS1D Operating Manual

Chapter 5. Basic operation for output channels

This chapter explains basic operation for MIX channels, MATRIX channels, and STEREO A/B channels.

About the output channels

Blocks used to control the output channels

The PM1D system provides MIX channels 1–48, MATRIX channels 1–24, and the STEREO A/B channels as output
channels for MIX buses 1–48, MATRIX buses 1–24, and the STEREO bus. The signals sent to these output channels is
routed through the internal six-band EQ and compressor, and is sent from the output jack that is patched by the OUT
PATCH function.
The following blocks of the CS1D console are used to control output channels.
MIX OUTPUT block
This block specifies the level and on/off setting of the
signals that are sent from the input channels and ST
IN channels to MIX buses 1–48, and sends them to
the output units patched to MIX channels, to the
STEREO bus, and to the MATRIX buses.
MATRIX OUTPUT block
This block specifies the level and on/off setting of the
signals that are sent from MIX channels 1–48, the
STEREO A channel, and the SUB IN channels to
MATRIX buses 1–24, and outputs them from the
output units that are patched to the channels.
MATRIX OUTPUT block
MIX OUTPUT block
STEREO OUTPUT block
This block mixes the signals that are sent from the
input channels/output channels to the STEREO bus,
and outputs them from the output units that are
patched to the STEREO A/B channels.
STEREO OUTPUT block
SELECTED OUTPUT CHANNEL block
This block selects the desired MIX channel, MATRIX
channel, or STEREO A/B channel L or R, and speci-
fies its on/off setting, EQ/compressor settings, and
output level.
SELECTED OUTPUT
CHANNEL block
59