Yamaha CS1D Operating Manual page 379

9 List
This list shows the event (scene recall/effect recall)
that is assigned to each program change number.
CH
This is the MIDI channel on which the program
change will be transmitted/received.
In Single mode when the BANK button is on, the
number in this column will indicate the bank num-
ber.
PGM No.
This shows the program number 1–128.
Be aware that some external devices may display the
program number as 0–127. When transmitting
program changes from such an external device to
the PM1D system, add 1 to the program number.
PROGRAM CHANGE EVENT
This shows the event that will be executed when the
program number of the corresponding MIDI chan-
nel is received.
When you click the button in the list, a popup
window will appear in which you can select the event
to be assigned to that program number.
When the event displayed in this column is executed
on the CS1D, the program change of the correspond-
ing MIDI channel will be transmitted.
[Procedure]
Executing a specific event when a given pro-
gram change is received
Here's how to make settings so that when a given pro-
gram change message is received from an external
device, the specific event (scene recall/effect recall)
assigned to that program change message will be exe-
cuted.
9
1. Connect the MIDI OUT connector of the external
device to the [MIDI IN] connector of the CS1D or
to the [MIDI IN] connector of the DSP1D-EX
{DSP1D}.
2. Access the MIDI/GPI/TC function MIDI PRO-
GRAM screen, and use the MIDI PORT buttons to
select the port at which you wish to receive the pro-
gram changes.
3. Turn on one of the MIDI MODE buttons to select
either Multi mode or Single mode as the program
change reception/transmission mode.
4. If you selected Single mode in step 2, use the TX
CH/RX CH knobs to specify the MIDI channels
that will be used to transmit and receive program
change messages. As necessary, turn on the OMNI
button or BANK button.
5. From the PROGRAM CHANGE EVENT list, select
the program number to which you wish to assign
an event, and click the
A popup window will appear, in which you can select
the event to assign.
MIDI/GPI/TC function
button in that column.
31