Yamaha CS1D Operating Manual page 411

5 TB ON/OFF (talkback on/off)
This switch turns talkback on/off.
This switch is linked with the [TB ON] switch on the
CS1D top panel.
6 TB OUT (talkback direct output)
In this section you can patch the talkback signal to
physical output jacks for direct output.
When you click the button, the TB DIRECT OUT
popup window will appear, in which you can select
the jacks for direct output.
You can also use the ON/OFF button to switch direct
output on/off. (The ON/OFF button is linked with
the TALKBACK ASSIGN [TB OUT] switch located
on the CS1D top panel.)
7 ASSIGN
Select the bus or output jack that will send the talk-
back signal, from the following choices. (More than
one may be selected.)
STEREO..............STEREO bus
MONITOR B ......MONITOR OUT jack B
MIX 1–48............MIX buses 1–48
MATRIX 1–24 ....MATRIX buses 1–24
5
6
[Procedure]
Using the Talkback function
1. Connect a talkback mic to the TALKBACK 1 jack
2. Access the MON/CUE function TALKBACK screen.
3. Use the buttons of the TALKBACK screen ASSIGN
4. Press the [TB ON] switch located in the TALK-
7
MON/CUE (monitor/cue) functions
Hint
The MONITOR B button is linked with the TALK-
BACK ASSIGN [TO MON B] switch located on the
CS1D top panel.
You can also send the talkback signal to a desired
input channel, and use it as a dedicated talkback
channel. To do so, use the IN PATCH function
INPUT PATCH screen to patch the talkback signal to
the desired input channel.
located on the CS1D top panel, and to the TALK-
BACK 2 jack located on the rear panel.
Hint
The input signals from the TALKBACK 1 jack and
the TALKBACK 2 jack are mixed by the PM1D sys-
tem, and are output to the same bus or output jack.
Both jacks can be used simultaneously.
As appropriate for your mic(s), turn phantom
power on/off, switch the phase between normal/
inverted, and set the input level.
section to select the bus or output jack to which the
talkback signal will be output.
If necessary, you can also use the TB OUT section to
select a jack that will directly output the talkback sig-
nal, or use the IN PATCH function INPUT PATCH
screen to patch the talkback signal to the desired
input channel.
BACK section (MASTER block) of the CS1D.
The [TB ON] switch can be used in the following
two ways.
Press and hold the switch for two seconds or
longer
This is the usual way to use talkback.
Talkback will be on only while you continue pressing
the switch, and will be off when you release the
switch.
Press and immediately release the switch
The LED will stay lit even after you release the
switch, and Talkback will stay on.
When you once again press and immediately release
the switch, talkback will be turned off.
63