Yamaha CS1D Operating Manual page 128

CS1D Operating Manual (Basic Operation)
[Procedure]
1. Use the INPUT block [SEL] switches or the ST IN
block [L]/[R] switches to select the input channel
that you wish to control.
2. In the LCD FUNCTION ACCESS block, press the
INPUT [GATE/COMP] switch several times to
access the following GATE PRM screen.
LCD FUNCTION ACCESS
block
INPUT [GATE/COMP] switch
In the GATE PRM screen you can make noise gate
settings for the currently selected input channel.
GATE PRM screen
3. Click the INPUT GATE LIBRARY button located in
the upper right of the screen.
The following INPUT GATE LIBRARY popup win-
dow will appear. In this window you can store input
channel noise gate settings (input noise gate data) in
the library, or recall existing data from the library.
56
INPUT GATE LIBRARY popup window
Library list
This shows a list of the input noise gate data that has
been stored in memory. The highlighted row is currently
selected for operations. Rows numbered 01-04 are dis-
played as "READ ONLY," and contain read-only preset
data.
Edit section
This shows the settings of the
input noise gate data currently
selected in the library list.
4. From the library list, select data that uses the
desired type.
When you click a row in the library list, that row will
be highlighted, and the noise gate type used in that
data and the parameter settings will be displayed in
the edit section.
5. Click the RECALL button located in the lower left
of the library list.
The data you selected in step 4 will be recalled into
the input channel you selected in step 1.
You will exit the INPUT GATE LIBRARY popup
window and return to the previous GATE PRM
screen.
Hint
If a ST IN channel or either input channel of a pair is
selected, the same data will be loaded into both chan-
nels.
In the GATE PRM screen you can also select the key-
in signal (the reference signal that operates the noise
gate).
6. In the NOISE GATE section of the SELECTED
INPUT CHANNEL block, turn on the NOISE GATE
[ON] switch.
The noise gate will be turned on for the correspond-
ing channel.
7. Use the knobs and encoders in the NOISE GATE
section to adjust parameters such as ATTACK,
RELEASE, THRESHOLD LEVEL, and GAIN.
These buttons are used for
Store or Recall operations.