Yamaha CS1D Operating Manual page 283

1 STEREO [ON] switch and LED
This is the on/off switch for the STEREO A/B chan-
nel. (The LED will light when this is on.)
If this switch is off, no signal will be sent to the chan-
nel of the output unit that is patched to the respec-
tive STEREO channel.
If you are using the PM1D system in LCR mode so
that the STEREO B channel controls the signal of the
CENTER bus, the [ON] switch of the STEREO B
channel will function as the on/off switch for the
CENTER bus.
1
ON
2
TO MTRX
4
SEL
INS
10
5
0
5
10
20
RCL
MUTE
30
SAFE
40
50
60
6
CUE
ST OUTPUT
A
ON
3
MONO
SEL
5
INS
10
5
0
5
10
20
7
RCL
MUTE
30
8
SAFE
40
50
60
9
CUE
ST OUTPUT
B
2 STEREO A [TO MTRX] switch and LED (STEREO
A channel only)
This is the on/off switch for the signal that is sent
from the STEREO A channel to the MATRIX buses.
(The LED will light when this is on.)
If this switch is off, no signal will be sent from the
STEREO A channel to any MATRIX bus.
When the STEREO A [TO MTRX] switch is on, you
can use the knobs in the display (MATRIX/ST func-
tion MATRIX/ST ROUTING screen) to set the send
levels of the signals that are sent from the STEREO
A channel to MATRIX buses 1–24.
Note that these send level settings can be made only
in the display.
STEREO OUTPUT block
53