Sending A Signal From A Mix Channel To The Stereo Bus - Yamaha CS1D Operating Manual

Sending a signal from a MIX channel to the STEREO bus

Here's how the signal sent from an input channel to a MIX bus can be output to the STEREO bus.
[Procedure]
1. Make sure that an appropriate signal is being sent
from an input channel to the corresponding MIX bus.
2. In the MIX OUTPUT block, turn on the MIX [ON]
switch.
3. Turn on the MIX [TO ST] switch.
If MIX [TO ST] switch is off, the signal from that
MIX channel will not be sent to the STEREO bus.
4. Raise the MIX [LEVEL] encoder.
5. To adjust the panning of the signal sent from the
MIX channel to the STEREO bus, press the LCD
FUNCTION ACCESS block OUTPUT [MATRIX/
ST] switch several times to access the following
MATRIX/ST ROUTING screen.
LCD FUNCTION ACCESS
block
OUTPUT [MATRIX/ST] switch
MATRIX/ST ROUTING screen (MATRIX/ST function)
6. Drag the PAN knobs located in the MIX TO STE-
REO section to adjust the panning of the signal sent
from each MIX channel to the STEREO bus.
The current value is shown in the numerical box
located below the knob.
Chapter 5. Basic operation for output channels
Hint
By clicking the PRE button in the MIX TO STEREO
section, you can send the signal to the STEREO bus
from a point immediately before the [ON] switch of
the MIX OUTPUT block. This method is convenient
when you wish to send the MIX channel signal only to
the STEREO bus without sending it to an output unit.
7. In the STEREO OUTPUT block, turn on the STE-
REO A [ON] or STEREO B [ON] switch.
STEREO OUTPUT block
STEREO A
ON
[ON] switch
TO MTRX
SEL
INS
10
5
0
5
10
20
RCL
MUTE
30
SAFE
40
50
60
8. In the STEREO OUTPUT block, raise the STEREO
A or STEREO B fader.
The signal sent from the MIX channel to the STE-
REO bus will be output from the output jack patched
to the STEREO A or STEREO B channel.
9. So that the level of the signal output from the STE-
REO A/B channel (post-fader) can be viewed in the
meter bridge, turn off the METER [PRE] switch
located in the METER section of the MASTER
block.
STEREO B
ON
[ON] switch
MONO
SEL
INS
10
5
0
5
10
20
RCL
MUTE
30
SAFE
40
STEREO A/
50
60
STEREO B
faders
65