Yamaha CS1D Operating Manual page 372

Global functions
Hint
You may select two or more parameters for the same
channel (except for ALL).
ALL will automatically be selected for channels for
which individual parameters are not selected.
Selecting all parameters other than ALL will not
apply Recall Safe to all parameters of that channel. If
you want to protect all parameters of the channel,
you must select ALL.
Even if a certain unit is set to Recall Safe, HA AB
LINK will not be subject to Recall Safe. Also, HA
GAIN GANG will operate according to the setting
prior to the recall operation. These are included in
ALL.
If the unit or card type is changed when a new scene or
unit library is recalled, the Recall Safe setting of that
unit will be defeated.
3
4
3 SET ALL
When you click this button, the SAFE PARAMETER
SELECT button of the corresponding parameter/unit
will be turned on for all channels.
If the SET ALL button is on, even units not dis-
played in this screen will all be set to Recall Safe. Be
aware that units not currently patched and units
that are patched to Insert will also be affected.
4 CLEAR ALL
When you click this button, the SAFE PARAMETER
SELECT button of the corresponding parameter/unit
will be turned off for all channels.
24
5
5 OTHERS
Using these buttons, elements other than the above
channel parameters can be selected for Recall Safe
status. The following parameters can be selected.
DCA 1–12 ................ DCA groups 1–12
GEQ 1–24................. Graphic EQ modules 1–24
EFFECT 1–8............. Internal effects 1–8
MUTE MASTER...... Turn all mute groups on/off
Recall Safe is not possible for GEQ and EFFECT
when an individual library is recalled.
It is not possible to specify Recall Save individually
for mute groups 1–12.
For parameters like those listed below of which there
is only one for a pair of two adjacent odd-numbered
even-numbered channel, Recall Safe will be valid
only if Recall Safe is set for both channels.
HA GAIN GANG
HA A/B LINK
GATE LINK
COMP LINK
DELAY GANG
PAN MODE
GEQ LINK
Hint
In the case of two paired channels, a ST IN channel,
or the STEREO A/B channels, all settings that are set
to Recall Safe will be linked for both channels.
Recall Safe is not possible if a scene is recalled during
PREVIEW.
If Recall Safe is specified for either (not both) the
odd-numbered or even-numbered channel of two
channels, and you recall a scene in which these two
channels are paired, pairing will be forcibly defeated,
and the channel that was set to Recall Safe will main-
tain the state prior to the recall.
For channels in which the SEND parameter is set to
Recall Safe, VARI PAN LINK will forcibly be defeated
when a new scene is recalled.
If you specify Recall Safe for channels whose pairing
settings would be modified by a scene recall, the
SAFE PARAMETERS of both paired channels will be
forcibly handled as "ALL."
If a MIX channel that is set to Recall Safe has a differ-
ent mix type (VARI or FIX) before and after a scene
recall, the mix type prior to the recall will remain
valid.