Monitor The Input Signal - Yamaha CS1D Operating Manual

CS1D Operating Manual (Start-up)

Monitor the input signal

After you have patched an input source to an input channel, press the [CUE] switch for that input channel and check
whether it is output from the MONITOR OUT jacks.
[Procedure]
1. Play back the input source, and check that the
meter LEDs light for input channels 1/49 and 2/50
in INPUT block 1 of the console.
INPUT block 1
PAN PAN
L R L R
+48V +48V
INS A INS
B
TO ST TO ST
INPUT INPUT
GAIN GAIN
+10 -68 +10 -68
CLIP CLIP
+ +
THR THR
- -
COMP COMP
+ +
THR THR
- -
SEL GATE SEL GATE
CLIP CLIP
6 6
ON ON
12 12
18 18
30 30
60 60
50 50
60 60
CUE CUE
If the input source is connected to a mic/line input
card (LMY2-ML), adjust the [GAIN] encoder so
that the CLIP segment of the meter LED does not
light.
2. Press the [CUE] switches of input channels 1/49
and 2/50 to make the switch LEDs light.
The input signals of input channels 1/2 will be sent to
the monitoring bus (CUE bus).
36
A
B
[GAIN] encoder
Meter LEDs for
input channels 1/49
and 2/50
[CUE] switch
In the CUE section of the MASTER block, make
sure that the [SOLO] switch, the [INPUT AFL]
switch, and the [LAST CUE] switch are off (LED
dark). If any of these switches are on, it may not be
possible to monitor the signal from the MONITOR
OUT A jacks or the MONITOR A headphone jack
even though the [CUE] switch of the input channel
is pressed.
Monitoring will also be impossible if the CUE
INTERRUPTION button has been turned off in the
MON/CUE function MONITOR A screen. Please
check whether this button has been turned off.
("CS1D Reference Manual (Software)"
[INPUT AFL]
switch
[SOLO]
switch
3. In the MONITOR A section of the MASTER block,
turn on the MONITOR A [ON] switch and raise the
MONITOR A [LEVEL] volume to an appropriate
level. Also raise the volume of your monitor system.
MONITOR A
[LEVEL] volume
MONITOR A
[ON] switch
p.71.)
MASTER block
[LAST CUE] switch
MONITOR A
PHONES [LEVEL]
volume