Head Amp Settings - Yamaha CS1D Operating Manual

CS1D Operating Manual (Basic Operation)

Head amp settings

Here's how to use the SELECTED INPUT CHANNEL block to make head amp settings for an input channel to which a
mic/line input card (LMY2-ML) has been patched.
Hint
Even for ST IN channels or input channels that have been paired, head amp settings must be made independently.
Select each channel in turn, and make settings for it.
[Procedure]
1. Use the INPUT block [SEL] switches or the ST IN
block [L]/[R] switches to select the input channel
that you wish to control.
In order to use the SELECTED INPUT CHANNEL
block, you must first select the input channel (or ST
IN channel L/R) that you wish to control.
INPUT block
[SEL] switch
ST IN block
SEL [L]/[R] switch
When you select a channel, the LEDs and indicators
of the SELECTED INPUT CHANNEL block will
show the settings of the various parameters for that
channel. The number and short name of that chan-
nel will be displayed in the CHANNEL SELECT sec-
tion by the [NAME]/[NUMBER] indicator.
SELECTED INPUT CHANNEL
block
SHIFT
DEC
CHANNEL SELECT
46
+
THR
-
COMP
+
THR
-
GATE
SEL
L CLIP R
+
THR
L
-
SEL COMP
+
THR
R
-
SEL GATE
[NAME]/[NUMBER]
indicator
INC
[NAME] will not be displayed for channels that are
not patched to an input unit.
The number shown by the [NUMBER] indicator
corresponds to the channel as follows.
1–96 {1–48}........ Monaural input channels 1–96
{1–48}
1L, 1R ... 8L, 8R .. ST IN channels 1–8 {1–4} L or R
Hint
You can also use the CHANNEL SELECT [ /DEC]/
[ /INC] switches of the SELECTED INPUT
CHANNEL block to select the channel. For details
refer to "CS1D Reference Manual (Hardware)"
( p.34).
2. In the SELECTED INPUT CHANNEL block, use the
+48/ø/INSERT section to switch the phase and
phantom power on/off for the selected channel.
If the [+48V] switch is on, +48V phantom power will
be supplied to the corresponding input jack. If the
[ø] switch is on, the phase of the input signal will be
reversed.
+48/ø/INSERT section
+48V
+48V /
[+48V] or [ø] may not be operable, depending on
the type of input unit that is patched. The +48V
switch located on the front panel of the AI8 input
unit functions as the master phantom switch for the
entire unit. This means that if the master phantom
switch is off, phantom power cannot be used for
that unit.
3. In the SELECTED INPUT CHANNEL block, use the
INPUT section to select either input jack A or B of
the mic/line input card.
The switch LED for the currently selected input jack
(A/B) will light.
This may not be operable, depending on the type of
input unit that is patched.
INSERT
/ INSERT