Sending A Signal From An Input Channel To A Stereo Bus - Yamaha CS1D Operating Manual

CS1D Operating Manual (Basic Operation)

Sending a signal from an input channel to a STEREO bus

Here's how to use the INPUT block/ST IN block to send an input channel signal to a STEREO bus.
Hint
The procedure described here uses the example of an input channel, but virtually the same procedure applies to ST
IN channels as well.
[Procedure]
1. Make sure that an input source is correctly patched
to the input channel, and that the head amp is set
appropriately.
2. In the INPUT block, turn on the INPUT [ON]
switch.
3. Turn on the INPUT [TO ST] switch.
4. Raise the INPUT fader.
The input channel signal will now be sent to the
STEREO buses.
Hint
If the PM1D system is in its initial state, the STEREO
A/STEREO B section of the meter bridge block will
show the level of the signals sent to the STEREO bus
(the pre-attenuator level of STEREO A/B channels).
5. As necessary, use the INPUT [PAN] encoder to
adjust the panning of the signal.
The peripheral LEDs will indicate the approximate
current value. If the
the signal is panned to the center.
When sending signals from a ST IN channel to the
STEREO bus, use the ST IN SEL [L]/[R] switches to
select each channel separately, and set the ST IN
[PAN] encoder separately for L and R.
38
LED is lit, this indicates that
6. In the STEREO OUTPUT block, turn on the STE-
REO A [ON] or STEREO B [ON] switch.
The STEREO OUTPUT block is where signals sent to
the STEREO bus are output via the STEREO A/B
channels to an output unit.
STEREO OUTPUT block
STEREO A
ON
[ON] switch
TO MTRX
SEL
10
5
0
5
10
20
30
SAFE
40
50
60
7. In the STEREO OUTPUT block, raise the STEREO
A or STEREO B fader.
The signal sent from the input channel to the STE-
REO bus will be output from the output jack(s)
patched to the STEREO A or STEREO B channel.
STEREO B
ON
[ON] switch
MONO
SEL
INS INS
10
5
0
5
10
20
RCL RCL
MUTE MUTE
30
SAFE
40
STEREO A/
50
60
STEREO B
faders