Yamaha CS1D Operating Manual page 306

CS1D Reference Manual (Hardware)
10 11 12
(2) Switching on-screen
In the ASSIGN TO DCA FADERS buttons located in
the lower right of the screen, click the desired button.
1.60 k – 20.0 k button
The twelve bands from 1.6 kHz–20 kHz will be
assigned to the DCA faders.
200–2.50 k button
The twelve bands from 200 Hz–2.5 kHz will be
assigned to the DCA faders.
20–250 button
The twelve bands from 20 Hz–250 Hz will be
assigned to the DCA faders.
76
IN
1.60k–20.0k
1–12
200–2.50k
13–24
20–250
25–36
37–48
OFF
DCA
FADER
STATUS
By clicking one of the above buttons, you can use the
DCA faders to control the graphic EQ.
In this case, the [FADER STATUS] switches located
above the DCA GROUP block on the CS1D top
panel will function as band select switches for the
bands of the graphic EQ, as shown in the following
illustration. (The LEDs will light to indicate the
[FADER STATUS] switches that can be used as band
select switches.) In this case, the FADER STATUS
[IN] switch and the FADER STATUS [37-48] switch
will have no effect.
10 11 12
7. Operate DCA faders 1–12.
The corresponding frequency bands will be boosted
or cut.
8. If you wish to use the DCA faders to control other
bands, repeat steps 7–8.
9. To stop using the DCA faders to control the graphic
EQ, press the FADER STATUS [DCA] switch on the
CS1D. Alternatively, click OFF in the ASSIGN TO
DCA buttons of the GEQ PARAMETER screen.
The [FADER STATUS] switches of the CS1D will
return to their original state.
To once again assign the graphic EQ to the DCA fad-
ers, click one of the ASSIGN TO DCA buttons in the
GEQ PARAMETER screen.
When you exit the GEQ PARAMETER screen,
assignments to the DCA faders will be forcibly can-
celed, and the DCA faders will return to their previ-
ous state.
IN
1.60k–20.0k
1–12
200–2.50k
13–24
20–250
25–36
37–48
OFF
DCA
FADER
STATUS