Yamaha CS1D Operating Manual page 362

Global functions
However, if executing this would cause a module pre-
viously assigned to a different channel to be cancelled,
a popup window will appear, warning you of this.
If you select an input channel as the GEQ insert des-
tination, the INS. button of the corresponding chan-
nel will automatically be turned on in the IN PATCH
function INSERT/DIRECT POINT screen.
If you select an output channel as the GEQ insert
destination, the INS. button of the corresponding
channel will automatically be turned on in the OUT
PATCH function INSERT POINT screen.
5
6
5 Spectrum analyzer
This spectrum analyzer displays the level of each fre-
quency band in the input signal.
7
7 Faders
These faders boost/cut each frequency band of the
graphic EQ. The amount of boost/cut is shown in the
numerical box below.
Hint
The allowable maximum range and direction of
change for the faders will depend on the setting of
the LIMIT parameter (8).
A red line displayed in the knob portion of the fader
indicates that it can currently be controlled by the
DCA faders of the CS1D.
0 NOTCH 1–4
These are four notch filters that operate on the signal
route selected by INSERT (2).
14
3 GEQ ON/OFF
This button switches the currently displayed graphic
EQ on/off.
Hint
This button does not affect the notch filters (0).
4 LINK
This button links adjacent odd-numbered
numbered GEQ modules.
6 EQ graph
This graph shows the current frequency response of
the graphic EQ.
8 LIMIT
This button sets the allowable maximum range and
direction of change for the faders.
You can ±15 dB, ±12 dB, ±6 dB (for both boost or
cut), or –24 dB (for cut only).
9 EQ FLAT
This button resets the faders of all bands to the 0 dB
position.
0
Use the NOTCH 1–NOTCH 4 buttons to switch each
filter on/off, use the Q knob to adjust the steepness,
and use the F knob to adjust the center frequency.
even-
8
9