Yamaha CS1D Operating Manual page 6

Additions and changes in the
OUTPUT UNIT screen
The following two additions/changes have been made in
the SYS/W.CLOCK function OUTPUT UNIT screen.
1
1 UNIT SELECT button
This button virtually connects a unit to the jack
selected by the OUT 1–OUT 6 buttons. This is the
same function as the UNIT SELECT button located
in the upper right of the screen in the software of the
previous version.
When you click this button, a popup window will
appear, allowing you to select a unit.
Hint
In V1.25, the model names (A08-DA8) of cards that
are already installed can be selected directly. If you
select a model name, it will not be necessary to spec-
ify the installed card.
2 UNIT LIBRARY button
A button has been added that allows you to access the
UNIT LIBRARY window, where you can store/recall
setting data for all units. This button has the same
function as the UNIT LIBRARY button located in the
OUT INSERT function ST MAS INS/UNIT LIB
screen.
Reference pages
Software section, pages 50–51
Additional master clocks available
for selection
(WORD CLOCK screen)
In the SYS/W.CLOCK function WORD CLOCK screen,
the following three types have been added to the master
2
clocks that can be selected.
In particular when using Mirror mode, selecting the
console's INT 48k or INT 44.1k as the master clock will
allow you to construct a system that does not use an
external clock generator.
In this case, connections and settings will be as shown
on the following page.
CONSOLE INT 48k
The internal clock of the CS1D (48 kHz)
CONSOLE INT 44.1k
The internal clock of the CS1D (44.1 kHz)
W.CLOCK IN
The word clock supplied to the WORD CLOCK IN
jack of the CS1D
• The above master clocks are displayed only if the
setting level is set to "ADVANCED" in the WORD
CLOCK screen.
• Some of the buttons in the WORD CLOCK
screen are arranged differently in V1.25.
5