Yamaha CS1D Operating Manual page 597

Appendices
High frequency range is muted
Is emphasis being applied? If the emphasis data does
not match the input signal, the high frequency range
will be muted. ("CS1D Reference Manual (Soft-
ware)" p.133)
Is EQ applied? ("CS1D Operation Manual (Basic
Operation)" p.57, 83)
The [ON] switches and [SEL] switches select
the wrong channel
Make sure that the correct mixing layer is selected.
("CS1D Reference Manual (Hardware)"
41, 47)
An input signal is being received, but there
is no monitor output
Is "CUE INTERRUPTION" turned on? If CUE is
ON, the CUE signal will be output from MONITOR
OUT. ("CS1D Reference Manual (Software)"
A channel continues to be heard even in
SOLO mode
Is that channel set to SOLO SAFE? ("CS1D Reference
Manual (Software)"
Insufficient headroom, especially when EQ
is boosted
Use the EQ attenuator to lower the level. ("CS1D
Reference Manual (Hardware)"
Sound recorded via ST OUT DIGITAL or a MY
card with digital output appears fragmented
Make sure that the dither setting matches the word
length of the recording device. ("CS1D Reference
Manual (Software)"
Signal phase is incorrect for a stereo pair
You must set both input channels of a stereo pair to
the same phase setting. Phase settings are not linked
when you specify stereo pairing. ("CS1D Reference
Manual (Hardware)"
Signal appears to be delayed
Make sure that the channel delay function is set cor-
rectly. ("CS1D Reference Manual (Hardware)"
p.22)
Some channels are not updated when a
scene memory is recalled
Are those channels set to Recall Safe? ("CS1D Opera-
tion Manual (Basic Operation)"
52
p.5, 13,
p.71)
p.74)
p.29)
p.56)
p.21)
p.106)
I selected CUE in the EFFECT screen, but it
is defeated without my action
This will be defeated automatically when you switch
to a different display screen. ("CS1D Reference Man-
ual (Software)" p.10)
Cannot make boost settings in the GEQ
Is the LIMIT set to –24 dB? ("CS1D Operation Man-
ual (Basic Operation)" p.136)
When a scene is recalled, some time is
required before faders stop moving
Has the fade time been set? ("CS1D Reference Man-
ual (Software)" p.25)
Unconnected units or uninstalled cards are
displayed
Have virtual unit or virtual card settings been made?
("CS1D Reference Manual (Software)"
CS1D panel LEDs are dim
Adjust the LED BRIGHTNESS setting in the PREF-
ERENCE screen of the UTILITY function. ("CS1D
Reference Manual (Software)"
The VERSION CHECK popup window
appeared
The software/firmware of the component that failed
the test does not match the version of the PM1D sys-
tem. The software/firmware of that component must
be updated.
For details on how to perform the update, refer to the
documentation on the included PM1D system soft-
ware disc.
p.47, 50)
p.36)