Yamaha CS1D Operating Manual page 285

5 STEREO [INS] LED
This LED indicates the insertion on/off status of the
STEREO A/B channel.
When insertion is on, the switch LED will light, and
the insert out/in points specified in the display
(OUTPUT PATCH function INSERT PATCH screen)
will be enabled.
6 STEREO fader
This is a 100 mm fader that adjusts the output level
of the STEREO A/B channel.
The range is – dB – +10 dB.
If you are using the PM1D system in LCR mode so
that the STEREO B channel controls the signal of the
CENTER bus, the STEREO B channel fader will con-
trol the output level of the CENTER bus.
7 STEREO SAFE [RCL] LED
This LED will light if the STEREO A/B channel is in
Recall Safe mode (a condition in which the channel
will be unaffected by scene recall operations).
The parameters of a channel whose LED is lit will not
change even if a scene memory is recalled.
Recall Safe settings can be made in the SELECTED
OUTPUT CHANNEL block or in the display
(SCENE function RECALL SAFE screen).
8 STEREO SAFE [MUTE] LED
This LED will light if the STEREO A/B channel is in
Mute Safe mode (a condition in which the channel
will be unaffected by mute group operations).
A channel whose LED is lit will not be affected if a
mute group to which it belongs is muted.
Mute Safe settings can be made in the SELECTED
OUTPUT CHANNEL block or in the display (OUT
DCA/MUTE function MUTE GROUP ASSIGN
screen).
9 STEREO [CUE] switch and LED
This switch monitors the STEREO A/B channel.
When you press this switch, the PFL (pre-fader lis-
ten) or POST ON (after the [ON] switch) signal of
the corresponding channel will be sent to the CUE
bus, and can be monitored from the CUE OUT jacks,
MONITOR OUT jacks A, and PHONES jack.
The location of the signal sent to the CUE bus and
the monitoring method can be selected from the
CUE section of the console, or in the display (MON/
CUE function CUE/SOLO screen).
Hint
For details on the signal flow of the STEREO A/B
channels, refer to the block diagram on page 68.
STEREO OUTPUT block
55