Patch The Input Unit To An Input Channel - Yamaha CS1D Operating Manual

Patch the input unit to an input channel

Simply connecting a source to an input unit does not cause that signal to be input to the PM1D system. In order to send
signals to the PM1D system, you must assign (patch) the input jacks of the input unit to input channels of the PM1D sys-
tem. This operation is performed within the display of the CS1D console.
[Procedure]
1. Turn on the power in the order of PM1D system
monitor system.
2. In the LCD FUNCTION ACCESS block, press the
INPUT [PATCH] switch several times to access the
following screen.
LCD FUNCTION ACCESS
block
INPUT [PATCH] switch
This is the INPUT PATCH screen, where signals
from an input unit or effect return can be patched to
input channels.
Checking the operation of input units
33