Tc Event (Time Code Event) - Yamaha CS1D Operating Manual

TC EVENT (time code event)

[Function]
When LTC time code received from an external device (or time code generated within the CS1D) reaches a
certain time, the specified scene will be recalled.
This function will operate only while the CS1D and DSP1D are connected and operating.
Console
In the LCD FUNCTION ACCESS
block, press the [MIDI/GPI/TC]
switch (press repeatedly until the
screen shown at the right appears)
Display
MENU button MIDI/GPI/TC
button TC EVENT tab
[Screen functions]
1
2
3
4
5
1 EVENT RECALLING (event recall on/off)
This button specifies whether or not the scene recall
will be executed when the received time code (or the
internally generated time code) reaches the specified
location.
Be aware that while this button is set to "ENABLE", it
is not possible to store scenes, units, patches or
names, or to load memory card data.
2 TIME CODE IN
These buttons select the time code source. You can
select from the following sources.
CONSOLE ......Time code (LTC) will be received
from the [TIME CODE IN] con-
nector of the CS1D.
ENGINE A ......Time code (LTC) will be received
from the [TIME CODE IN] con-
nector of the DSP1D-EX {DSP1D}
connected to the ENGINE A con-
nector of the CS1D.
ENGINE B.......Time code (LTC) will be received
from the [TIME CODE IN] con-
nector of the DSP1D-EX {DSP1D}
connected to the ENGINE B con-
nector of the CS1D.
INT GEN .........The time code generated by the
PM1D system itself will be used.
The instant you click this button,
the time code internally generated
by the PM1D will start at the time
specified by INT GEN START
TIME (4).
MIDI/GPI/TC function
33