Chapter 4. Basic Operation For Input Channels; About Input Channels; Blocks Used To Control Input Channels - Yamaha CS1D Operating Manual

Chapter 4. Basic operation for input channels

This chapter explains basic operation for input channels/ST IN channels.

About input channels

Blocks used to control input channels

On the PM1D system, you can use 96 {48} monaural input channels and 8 {4} stereo ST IN channels. A signal patched to
one of these input channels passes through the internal four-band EQ/compressor/gate, and is sent to the STEREO bus
or MIX bus.
The following blocks on the CS1D console are used to control input channels.
INPUT blocks 1–4
These blocks adjust the pan and level etc. of monau-
ral input channels 1–96 {1–48} and send them to the
STEREO bus or MIX bus. Each block contains 12
channels of modules.
INPUT block 2
INPUT block 1
ST IN block
This block adjusts the pan and level etc. of the stereo
ST IN channels 1–8 {1–4} and send them to the STE-
REO bus or MIX bus.
32
INPUT block 4
INPUT block 3
ST IN block
SELECTED INPUT CHANNEL block
This block controls most of the mix parameters for
the selected input channel or for the L or R channel
of a ST IN channel, such as head amp settings, EQ/
compressor/gate settings, and send to the STEREO
bus or MIX bus.
SELECTED INPUT CHANNEL block