Head Amp Settings - Yamaha CS1D Operating Manual

CS1D Operating Manual (Basic Operation)

Head amp settings

For channels to which a mic/line amp card (LMY2-ML) has been patched, you must complete various settings for the
head amp (e.g., select input jacks A/B, turn phantom power on/off) before you continue.
Hint
This section explains the procedure for an input channel. If you are using a ST IN channel, head amp settings must be
made separately for L and R. Use the ST IN SEL [L]/[R] switches to select each channel and make settings.
[Procedure]
1. In the LCD FUNCTION ACCESS block, press the
INPUT [HA/INSERT] switch several times to access
one of the following screens.
LCD FUNCTION ACCESS
block
INPUT [HA/INSERT] switch
1-24/25-48/49-72/73-96
In these screens you can make settings for input
cards that have been patched to input channels 1–
24/25–48/49–72/73–96 respectively. {On the 48
channel model, the 49-72 and 73-96 screens are
not valid.}
ST IN 1–8
In this screen you can make settings for input cards
that have been patched to ST IN channels 1–8 {1–4}.
1–24 screen (IN HA/INSERT function)
36
Within the IN HA/INSERT function screen, the
"INS" tab is a screen where you can make settings
for the input cards patched to an Insert In point.
Please do not confuse this with the screens listed
above.
The following parameters will be displayed for a
channel to which an LMY2-ML mic/line input card
has been patched.
Display for a channel to which an LMY2-ML has
been patched
Level meter
This level meter indicates the input level.
GAIN GANG
This button links the head amp gain of adjacent input
channels in the screen (or of the L and R of a ST IN
channel).
A/B LINK
This button links the A/B input jack selection
for adjacent input channels in the screen (or
for the L and R of a ST IN channel).
GAIN
This knob adjusts the input sensitivity of
the head amp.
ø (phase)
This button switches the input signal
between normal and reversed phase.
+48V
This is an on/off button for the phantom power of the
mic/line input card.
2. Use the A/B button in the screen to select the input
jack (A/B) of the card that each channel will use.
3. Use the ø and +48V buttons in the screen to switch
the phase and phantom power on/off for each chan-
nel.
If the ø button is turned on, the phase of the input
signal will be reversed. If the +48V button is turned
on, +48V phantom power will be supplied to the cor-
responding input jack.
A/B
These buttons
switch between
input jacks A
and B of the
mic/line input
card.