Sending a signal from a MIX channel to a MATRIX bus/STEREO bus
Here's how you can use the SELECTED OUTPUT CHANNEL block to send a MIX channel signal to the STEREO bus or
a MATRIX bus.
1. Use the [SEL] switches of the MIX OUTPUT block
to select the MIX channel that you wish to control.
2. To sent the MIX channel signal to the STEREO bus,
go to the OUTPUT section of the SELECTED OUT-
PUT CHANNEL block and turn on the [TO ST]
switch. If you wish to send the signal to a MATRIX
bus, turn on the [TO MTRX] switch.
[TO ST] switch
3. In the LCD FUNCTION ACCESS block, press the
OUTPUT [MATRIX/ST] switch several times to
access the following MATRIX/ST ROUTING
LCD FUNCTION ACCESS
OUTPUT [MATRIX/ST] switch
4. If you are sending the MIX channel signal to the
5. If you are sending the MIX channel signal to the
6. In the SELECTED INPUT CHANNEL block OUT-
7. In the OUTPUT section, raise the OUTPUT
Chapter 5. Basic operation for output channels
MATRIX/ST ROUTING screen (MATRIX/ST
STEREO bus, use the PRE button located in the
MIX TO STEREO section of the screen to specify
the point from which the signal will be sent from
the MIX channel to the STEREO bus.
If the PRE button is on, the signal from before the
[LEVEL] encoder (pre-fader) will be sent to the STE-
REO bus. If the PRE button is off, the signal from
after the [LEVEL] encoder (post-fader) will be sent
to the STEREO bus.
MATRIX bus, use the buttons of the on-screen MIX
TO MATRIX section to select one of the following
points from which the signal will be sent from the
MIX channel to the MATRIX bus.
PRE FADER ....... Immediately before the MIX
[LEVEL] encoder (pre-fader)
POST FADER .... Immediately after the MIX
[LEVEL] encoder (post-fader)
POST ON ........... Immediately after the MIX [ON]
PUT section, turn on the [ON] switch.
If pre-fader has been selected as the signal send
point, the signal will now be sent to the corre-