Mix Send Section - Yamaha CS1D Operating Manual

MIX SEND section

In this section, the signals sent from the currently selected channel to MIX buses 1–48 can be switched on/off, and their
send levels adjusted.
3
4
5
1 MIX SEND [PAIR] LED
This LED will light to indicate two adjacent odd and
even-numbered MIX buses 1–48 (MIX buses 1/2, 3/
4, ...) that are paired.
Mix bus pairing can be set or defeated on the console
by the MIX OUTPUT block MIX [SEL] switch, or in
the display (PAN ROUTING function etc.).
Hint
Before you perform this procedure, use the MIX
SEND LAYER [1-24]/[25-48] switches (7) to select
either MIX buses 1-24 or MIX buses 25-48 as the
send destination MIX buses.
2 1
PAIR
PAIR
PAIR
7
2 MIX SEND [LEVEL/PAN] encoder and LEDs
This encoder sets the send level of the signal that is
sent from the currently selected channel to a MIX
bus that is set to VARI.
The range of adjustment is –
approximate current value is shown by the perimeter
LEDs.
When the LED at the
nominal (0 dB).
However in the case of FIX type MIX buses, only the
LED at the
and the MIX SEND [LEVEL] encoder will be dis-
abled.
If the send destination MIX bus is paired, the
encoder for the left-hand MIX bus will function as
the MIX SEND [PAN] encoder, and the encoder for
the right-hand MIX bus will function as the MIX
SEND [LEVEL] encoder. The approximate current
value for each will be shown by the perimeter LEDs
around each encoder.
SELECTED INPUT CHANNEL block
6
dB – +10 dB, and the
symbol is lit, the level is
®
position of the input channel will light,
®
23