Yamaha CS1D Operating Manual page 397

[Procedure]
Making virtual connections for an input unit
You can make virtual connections for input units or
cards that are not actually connected.
Virtual connections can be made only if a unit/card
is not actually connected.
1. Access the SYS/W.CLOCK function INPUT UNIT
screen.
2. Use the IN1–IN10 buttons to select the jack to
which the input unit will be virtually connected.
The IN1–IN10 buttons correspond respectively to
INPUT jacks 1–6 of the DSP1D-EX {DSP1D}.
3. To virtually connect a unit to the currently selected
jack, click the UNIT SELECT button.
UNIT SELECT popup window
The UNIT SELECT popup window will appear, in
which you can select the type of unit.
The following units can be selected in this window.
AI8 (AI8 input unit)
AI8-ML8 (an input unit in which eight mic/line
input cards are installed)
AI8-ML4AD4 (an input unit in which four mic/
line input cards + four AD cards are installed)
AI8-AD (an input unit in which eight AD cards
are installed)
DIO8 1-4 (OUTPUT A jacks of DIO8 digital
input/output unit)
DIO8 5-8 (OUTPUT B jacks of DIO8 digital
input/output unit)
BLANK (no unit)
If you wish to independently use the OUTPUT A
jacks and OUTPUT B jacks of the DIO8 digital
input/output unit, you must set the PORT B
SELECTOR of the DIO8 to the 5-8 position. With
this setting, signals will be sent from the OUTPUT
A jacks to slots 1–4, and from the OUTPUT B jacks
to slots 5–8.
4. Click an icon to select the unit that you will connect
virtually.
If you select a unit of a different type than was speci-
fied previously, a window will appear to warn you of
this. Click the OK button, and the patching that had
been specified for the previous unit will be defeated.
SYS/W.CLOCK (system/word clock) function
UNIT CONFLICT window warning that the unit has
been changed
Hint
Virtually connected units are shown by a yellow icon.
5. To virtually connect a card to the currently selected
unit, click the card assign button for the desired slot.
A list of the cards that can be installed in that unit
will be displayed.
6. Click the card that you wish to virtually connect.
Hint
Virtually-connected cards will be indicated by "VIR-
TUAL" displayed on a yellow background.
7. Make virtual connections for other units and cards
in the same way.
Hint
When the CS1D goes off-line, and the virtually-con-
nected units/cards differ from the physically-connected
units/cards, a popup window will appear, informing
you that the settings have been modified according to
the units/cards that are actually connected.
If in step 3 you selected the model name (AI8-ML8,
AI8-ML4AD4, AI8-AD8) of a unit in which a card is
already installed, it is not necessary to specify the card.
49