Effect Parameters - Yamaha CS1D Operating Manual

Recalling effect parameters
(EFFECT ASSIGN screen)
In the EFFECT function EFFECT ASSIGN screen, you
can now access the corresponding EFFECT 1–8 screen
by clicking the graphic that indicates the effect type. This
lets you operate effect parameters more quickly.
Reference pages
Software section, page 12
Using the encoders to control

effect parameters

(EFFECT 1–EFFECT 8 screens)
When the EFFECT function EFFECT 1–8 screens are
displayed, you can now use the encoders of the MIX
OUTPUT block to control the effect parameters. To do
this, use the following procedure to.
1. Access one of the EFFECT 1–EFFECT 8 screens.
2. Click the ASSIGN button located in the center of
the screen to turn it on.
2
ASSIGN button
The parameters of the currently selected effect will be
assigned to the MIX [LEVEL/BAL] encoders as
shown in the following diagram. At this time, the
MIX OUTPUT block MIX [NAME] indicator will
show the parameter name (up to four characters).
CS1D MIX OUTPUT block
ON ON ON ON ON ON
PAIR PAIR PAIR
ON ON ON ON ON ON
PAIR PAIR PAIR
Encoders 1–12
Hint
• When an EFFECT 1–EFFECT 8 screen is displayed,
you can hold down the [SHIFT/GRAB] switch of
the data entry block and press the MIX LAYER [1-
24] switch or the [25-48] switch to obtain the same
result.
• The ASSIGN button on/off setting is common to
all of the EFFECT 1–EFFECT 8 screens. If you
switch between EFFECT 1–EFFECT 8 screens
when the ASSIGN button is on, the parameters of
the new screen will be assigned.
3. To return to the previous state, click the ASSIGN
button to turn it off.
The encoder functions will return to their previous
state.
Hint
The encoder functions will also return to their previ-
ous state if you access a screen other than EFFECT 1–
EFFECT 8, or if you press either the MIX LAYER [1-
24] or [25-48] switch.
Reference pages
Basic operation, page 130
Software section, page 11
ON ON ON ON ON ON
PAIR PAIR PAIR
1-24
ON ON ON ON ON ON
PAIR PAIR PAIR
MIX
LAYER
Encoders 13–24