Yamaha CS1D Operating Manual page 400

Global functions
AO8 (AO8 output unit)
AO8-DA8 (an output unit in which eight DA
cards are installed)
DIO8 1-4 (INPUT A jacks of DIO8 digital input/
output unit)
DIO8 5-8 (INPUT B jacks of DIO8 digital input/
output unit)
BLANK (no unit)
If you wish to independently use the INPUT A jacks
and INPUT B jacks of the DIO8 digital input/out-
put unit, you must set the PORT B SELECTOR of
the DIO8 to the 5-8 position. With this setting, sig-
nals will be sent from the INPUT A jacks to slots 1–
4, and from the INPUT B jacks to slots 5–8.
4. Click an icon to select the unit that you will connect
virtually.
If you select a unit of a different type than was speci-
fied previously, a window will appear to warn you of
this. Click the OK button, and the patching that had
been specified for the previous unit will be defeated.
Hint
Virtually connected units are shown by a yellow icon.
UNIT CONFLICT window warning that the unit has
been changed
Hint
Virtually connected units are shown by a yellow icon.
5. To virtually connect a card to the currently selected
unit, click the card assign button for the desired
slot.
A list of the cards that can be installed in that unit
will be displayed.
52
6. Click the card that you wish to virtually connect.
Hint
Virtually-connected cards will be indicated by "VIR-
TUAL" displayed on a yellow background.
7. Make virtual connections for other units and cards
in the same way.
If in step 3 you selected the model name (AO8-DA8)
of a unit in which a card is already installed, it is not
necessary to specify the card.