Connections (Mirror Mode); Connecting The Console And Engines (Mirror Mode) - Yamaha CS1D Operating Manual

Connections (Mirror mode)

x2 x2
DSP
This section explains connections for Mirror mode, in which one console (CS1D) is connected to two engines (DSP1D-
EX {DSP1D}).

Connecting the console and engines (Mirror mode)

The following diagram shows typical connections between the console and engines for Mirror mode.
IN OUT
CONSOLE CONTROL
I/O I/O
ENGINE A
(DSP1D-EX{DSP1D})
WORD
CLOCK IN
1 Digital input/output connections
Use the included D-sub half pitch 68 pin cables to
connect the DIGITAL I/O ENGINE A connector of
the console to the CONSOLE I/O connector of engine
A, and the DIGITAL I/O ENGINE B connector of the
console to the CONSOLE I/O connector of engine B.
These connectors transmit and receive multi-channel
digital audio signals.
Use only Yamaha-manufactured D-sub half pitch 68
pin cables to connect the digital input/output con-
nectors. Operation cannot be guaranteed if any other
cables are used.
If you need cables of a different length than the
included D-sub half pitch 68 pin cables, please con-
tact your dealer.
The console and engines A/B each have two identical
sets of digital input/output connectors, numbered 1
and 2.
These two sets of connectors are completely identi-
cal, and the system will operate normally if just one
10
1
ENGINE A ENGINE B
DIGITAL
I/O
CONSOLE (CS1D)
DC POWER
WORD
CLOCK IN
INPUT A
POWER SUPPLY (PW1D)
Clock Generator
2
ENGINE A ENGINE B
IN OUT
IN OUT
CONTROL
I/O
3
4
set is connected. However, you may connect both 1
and 2 so that one of them can be used as a backup.
This method of connection is recommended for
most cases.
CONSOLE CASCADE
I/O
CONSOLE
1 IN 5
2 1
2 OUT 6
Engine B
IN OUT
CONSOLE CONTROL
I/O I/O
ENGINE B
(DSP1D-EX{DSP1D})
WORD
CLOCK IN
DIGITAL I/O
CONSOLE CASCADE
I/O
ENGINE B ENGINE A
1 IN
2 1 2 1
Console
(CS1D)
2 OUT
Engine A
5
6