Yamaha CS1D Operating Manual page 114

CS1D Operating Manual (Basic Operation)
INPUT block MIX SEND section
MIX SEND [NUMBER] indicator
This displays the short name and number of the
currently selected MIX bus.
MIX SEND [NAME] indicator
MIX SEND
Hint
As alternate ways to select the MIX bus that your
operations will affect, you can also use the MIX OUT
block MIX [SEL] switch, or the SELECTED OUT-
PUT CHANNEL block CHANNEL SELECT [ /
DEC]/[ /INC] switches. Since a ST IN channel does
not have a section corresponding to the MIX SEND
section, you can use these methods.
When the PM1D system is in its initial state, selecting
a MIX bus in one INPUT block will cause this selec-
tion to be reflected for the other INPUT blocks as
well.
However, MIX buses can be selected independently
for INPUT blocks whose MIX SEND [LOCAL]
switch is turned on.
6. Use the INPUT [MIX] encoder of the input channel
to adjust the send level of the signal that is sent
from that channel to the desired MIX bus.
The approximate current value is indicated by the
peripheral LEDs around the encoder. If the LED at
the mark is lit, the level is nominal (0 dB).
®
If a FIX type MIX bus is selected, the INPUT [MIX]
encoder has no effect, and only the nominal level
LED will be lit.
Hint
When the PM1D system is in its initial state, the MIX
OUT 1–24 and MIX OUT 25–48 sections of the
meter bridge block will indicate the level of the sig-
nals sent to each MIX bus (the pre-attenuator level of
the MIX channel).
It is also possible to temporarily exchange the func-
tions of the [MIX] encoders and faders of the input
channel/ST IN channels, so that you can use the fad-
ers to set the send levels. For details refer to "CS1D
Reference Manual (Software)."
42
MIX SEND [ /DEC]/[ /INC] switch
Select one of MIX buses 1–48 to control.
FIX
VARI
MIX SEND [FIX]/[VARI] LEDs
These LEDs indicate the type of the currently selected MIX bus.
MIX SEND [LOCAL] switch and LED
This specifies whether the MIX bus
number currently selected in the
INPUT block will be linked with other
INPUT blocks ([LOCAL] switch = off) or
can be switched independently of other
INPUT blocks ([LOCAL] switch = on).
DEC INC
7. In the MIX OUTPUT block, turn on the MIX [ON]
switch for the corresponding MIX channel.
The MIX OUTPUT block is where the signals sent to
each MIX bus are sent via the MIX channel to the
output unit.
MIX [ON]
switch
MIX [LEVEL]
encoder
8. In the MIX OUTPUT block, raise the MIX [LEVEL]
encoder for the appropriate MIX channel.
The signal sent from the input channel to the MIX
bus will be output from the output unit patched to
the corresponding MIX channel.
LOCAL
MIX OUTPUT block
ON ON
PAIR