Dlp-135 Connect Fes301 To 1677 Sonet Link - Alcatel-Lucent 1677 SONET Link Manual

3EM13850AD
Issue 01, September 2007
DLP-135
Connect FES301 to 1677 SONET Link
PURPOSE
This procedure provides instructions to connect an FES301 to the 1677 SONET Link.
PREREQUISITE
The 1677 SONET Link and the FES301 systems should be installed and turned up before
performing this procedure. Refer to the 1677 SONET Link Installation Practices manual
(PN 3EM13849AF) and Turn-Up manual (PN 3EM13850AD). Also refer to the
1353 NM Lite Operation and Administration manual (PN 3EM20511AB).
GENERAL
This procedure is performed using TL1 command entry on the 1677 SONET Link and the menu
screens on the FES301.
This procedure does not provide a method to make a direct communications connection between the
1677 SONET Link and the FES301. The two NEs are managed separately, with communications
through the 1353 NM. Communications with the 1353 NM should be set up after the connection
between the 1677 SONET Link and the FES301 is made. For information on configuring the EMA
and TL1DAT on a PC for the 1677 SONET Link, refer to 1677 SONET Link Operation and
Administration manual (PN 3EM13851AF). For information on configuring TL1DAT on a PC for the
FES301, refer to the Installation Guide for FES301 R03.01 CLEM R01.00.01
(PN 3EM17918AAABRJZZA).
FES301 modules must be running software release R03.01.06 before the FES301 can be connected
to the 1677 SONET Link. This procedure provides instructions to determine if FES301 modules need
to be upgraded.
Refer to the 1677 SONET Link Commands and Messages manual (PN 3EM13852AF) for more
information on the TL1 commands used in this procedure.
Table 135-A. Example of Telcordia GR-253 T1 to VT1 Mapping
VT1
VTG-1 DS1-1
VTG-2 DS1-2
VTG-3 DS1-3
VTG-4 DS1-4
VTG-5 DS1-5
VTG-6 DS1-6
VTG-7 DS1-7
Connect FES301 to 1677 SONET Link
VT2 VT3
DS1-8 DS1-15
DS1-9 DS1-16
DS1-10 DS1-17
DS1-11 DS1-18
DS1-12 DS1-19
DS1-13 DS1-20
DS1-14 DS1-21
DLP-135
VT4
DS1-22
DS1-23
DS1-24
DS1-25
DS1-26
DS1-27
DS1-28
4-211