Auto Detect Configuration Examples; Configuration Example For Auto Detect Implementation In Static Routing - 3Com WX3000 Series Operation Manual

To do...
Enter system view
Enter VLAN interface view
Enable the auto detect function
to implement VLAN interface
backup

Auto Detect Configuration Examples

Configuration Example for Auto Detect Implementation in Static Routing

Network requirements
As shown in
address 10.1.1.4, with 192.168.1.2 as the next hop, and the detecting number set to 1.
On switch A, configure a static route to Switch C.
Enable the static route when the detected group 8 is reachable.
To ensure normal operating of the auto detect function, configure a static route to Switch A on
Switch C.
Figure 1-1 Network diagram for implementing the auto detect function in static route
Configuration procedure
Configure the IP addresses of all the interfaces as shown in
omitted.
Configure Switch A.
# Enter system view.
<SwitchA> system-view
# Create detected group 8.
[SwitchA] detect-group 8
# Detect the reachability of 10.1.1.4/24, with 192.168.1.2/24 as the next hop, and the detecting number
set to 1.
[SwitchA-detect-group-8] detect-list 1 ip address 10.1.1.4 nexthop 192.168.1.2
[SwitchA-detect-group-8] quit
# Enable the static route when the detected group is reachable. The static route is invalid when the
detected group is unreachable.
[SwitchA] ip route-static 10.1.1.4 24 192.168.1.2 detect-group 8
Configure Switch C.
# Enter system view.
Use the command...
system-view
interface Vlan-interface
vlan-id
standby detect-group
group-number
Figure 1-1, create detected group 8 on Switch A; detect the reachability of the IP
—
—
Required
This operation is only needed
on the secondary VLAN
interface.
Figure 1-1. The configuration procedure is
1-4
Remarks