Multicast Static Routing Port Configuration - 3Com 8807 Configuration Manual

426 C 39: IGMP S
HAPTER
Multicast Static
Routing Port
Configuration
Introduction
Prerequisites
Configuring a Multicast
Static Routing Port
C
NOOPING ONFIGURATION
When you configure IGMP Snooping fast leave on aggregation ports, the
■
configuration takes effect only on primary aggregation ports.
If you add an IGMP V1 host of the same multicast group to the port, the switch
■
does not remove the port when the port receives an IGMP Leave packet of the
multicast group even you enable IGMP Snooping fast leave for the port.
By configuring a port in a VLAN to be a static routing port, you can enable IGMP
packets to be transparently transmitted through the port, meeting the
requirements of specific networks.
Ports and VLANs involved already exist.
■
Ports to be configured belong to corresponding VLANs.
■
You can configure a port in a VLAN to be a static routing port in VLAN view.
Table 418 Configure a port in a VLAN to be a static routing port in VLAN view
Operation
Enter system view
Enter VLAN view
Configure multicast static
routing port
You can also configure a port in a VLAN to be a static routing port in the
corresponding Ethernet port view.
Table 419 Configure a port in a VLAN to be a static routing port in Ethernet port view
Operation
Enter system view
Enter Ethernet port view
Configure multicast static
routing port
c
CAUTION:
You will fail to configure a port to be a static routing port if the port identified
■
by the port-number argument does not exist, or the port does not belong to
the VLAN.
Command
system-view
vlan vlan-id
multicast static-router-port
port-number
Command
system-view
interface interface-type
interface-number
multicast static-router-port
vlan vlan-id
Remarks
-
-
Provide the port-number
argument in the format of
interface-type
interface-number, where the
interface-type argument can
only be Ethernet port type.
By default, no static routing
port is configured.
Remarks
-
The interface-type argument
can only be Ethernet port
type.
By default, no static routing
port is configured.