Auto Detect Configuration Examples; Configuration Example For Auto Detect Implementation With Static Routing; Configuration Example For Auto Detect Implementation With Vrrp - 3Com 5500-EI PWR Install Manual

Auto Detect Configuration Examples

Configuration Example for Auto Detect Implementation with Static Routing

Network requirements
Create detected group 8 on Switch A; detect the reachability of the IP address 10.1.1.4, with
192.168.1.2 as the next hop, and the detecting number set to 1.
On switch A, configure a static route to Switch C.
Enable the static route when the detected group 8 is reachable.
To ensure normal operating of the auto detect function, configure a static route to Switch A on
Switch C.
Network diagram
Figure 1-3 Network diagram for implementing the auto detect function in static route
Configuration procedure
Configure the IP addresses of all the interfaces as shown in
omitted.
Configure Switch A.
# Enter system view.
<SwitchA> system-view
# Create detected group 8.
[SwitchA] detect-group 8
# Detect the reachability of 10.1.1.4/24, with 192.168.1.2/24 as the next hop, and the detecting number
set to 1.
[SwitchA-detect-group-8] detect-list 1 ip address 10.1.1.4 nexthop 192.168.1.2
[SwitchA-detect-group-8] quit
# Enable the static route when the detected group is reachable. The static route is invalid when the
detected group is unreachable.
[SwitchA] ip route-static 10.1.1.4 24 192.168.1.2 detect-group 8
Configure Switch C.
# Enter system view.
<SwitchC> system-view
# Configure a static route to Switch A.
[SwitchC] ip route-static 192.168.1.1 24 10.1.1.3

Configuration Example for Auto Detect Implementation with VRRP

Network requirements
Switch A and switch B form VRRP group 1, whose virtual IP address is 192.168.1.10.
Figure 1-3. The configuration procedure is
1-6