Static Route Configuration Example - 3Com 7757 Configuration Manual

Static Route
Configuration
Example
Table 212 Display the routing table
Operation
Display routing table summary
Display routing table details
Display the detailed information of a
specific route
Display the routes in a specified
address range
Display the routes discovered by a
specified protocol
Display the tree-structured routing
table information
Display the statistics of the routing
table
Clear the statistics about a protocol in
the routing table
Network requirements
As shown in Figure 69, it is required that all the hosts/Layer 3 switches in the
figure can communicate with each other by configuring static routes.
Network diagram
Figure 69 Static route configuration
1.1.5.1 /24
1 .1.2.2/24
1 .1.2.1/24
1.1.1.1/24
Switch A
1.1.1 .2/24
Host C

Static Route Configuration Example

Command
display ip routing-table You can execute the
display ip routing-table
verbose
display ip routing-table
ip-address [ mask ]
[ longer-match ]
[ verbose ]
display ip routing-table
ip-address1 mask1
ip-address2 mask2
[ verbose ]
display ip routing-table
protocol protocol
[ inactive | verbose ]
display ip routing-table
radix
display ip routing-table
statistics
reset ip routing-table
statistics protocol { all |
protocol }
Host A
1.1.5 .2/24
1.1 .3.1/24
Switch C
1 .1.3.2/24
1.1.4.1/24
Switch B
1.1.4.2 /24
Description
display command in any
view.
Use the reset command
in user view.
Host B
287