Delay Trigger - Rigol MSO8000A Series User Manual

• Level AB: adjusts the upper and lower limits of the trigger level at the same time,
and the trigger level deviation (the difference between the upper limit and lower
limit of the trigger level) remains unchanged.
NOTE
In Window trigger, pressing Trigger
type.
Rotate the Trigger
the adjustment of trigger level, two trigger level lines appear on the screen, and they
move up and down with the change of the trigger level. At the same time, the real-
time trigger level and slope information is displayed at the lower-left corner of the
screen (As shown in the figure below, H indicates the upper limit of the trigger level, L
indicates the lower limit of the trigger level, and △ indicates the trigger level
deviation). When you stopping modifying the trigger level, the trigger level line and
the trigger level information at the lower-left corner of the screen disappear in about
2 s. The current trigger level deviation is displayed at the upper-right corner of the
screen.
Trigger Mode:
In the trigger control area (Trigger) on the front panel, press
the current trigger mode. For details, refer to descriptions in "
Trigger Parameter Setting:
Sets the trigger parameters (trigger holdoff and noise rejection) under this trigger
type. For details, refer to descriptions in "
8.7.10

Delay Trigger

In Delay trigger, you need to set Source A and Source B. The oscilloscope triggers
when the time difference (△T) between the specified edges of Source A (Edge A) and
Source B (Edge B) meets the preset time limit, as shown in the figure below.
NOTE
Edge A and Edge B must be two neighboring edges.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
LEVEL can quickly switch the current level adjustment
LEVEL knob to adjust the corresponding trigger level. During
Trigger Holdoff
To Trigger the Oscilloscope
to quickly switch
Trigger Mode
".
Noise Rejection
" and " ".
103