Triggering the Oscilloscope
Trigger Parameter Setting
You can refer to
noise rejection under this trigger type.
8.7.10
Delay Trigger
In Delay trigger, you need to set Source A and Source B. The oscilloscope triggers
when the time difference (∆T) between the specified edges (Edge A and Edge B) of
Source A and Source B meets the preset time limit, as shown in the figure below.
Edge A and Edge B must be two neighboring edges.
Trigger Type
Click or tap the drop-down button of Type to select "Delay".
After a trigger type is selected, the current trigger setting information (including
trigger type, trigger source, and trigger level) is displayed in the trigger information
HDO1000 User Guide
90
Trigger Holdoff
Noise Rejection
and
Edge A
Source A
Source B
T
Figure 8.18 Delay Trigger
Figure 8.19 Delay Trigger Setting Menu
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
to set the trigger holdoff and
Edge B