Table of Contents
Advertisement
Chapter 5 To Trigger the Oscilloscope
Level AB: adjusts the upper and lower limits of the trigger level at the same time,
⚫
and the trigger level deviation (the difference between the upper limit and lower
limit of the trigger level) remains unchanged.
Note:
In Window trigger, pressing Trigger
current level adjustment type.
Rotate the Trigger
During the adjustment of trigger level, two trigger level lines appear on the screen,
and they move up and down with the change of the trigger level. At the same time,
the real-time trigger level and slope information is displayed at the lower-left corner
of the screen (as shown in the figure below, H indicates the upper limit of the trigger
level, L indicates the lower limit of the trigger level, and △ indicates the trigger level
deviation). When you stopping modifying the trigger level, the trigger level line and
the trigger level information at the lower-left corner of the screen disappear in about
2 s. The current trigger level deviation is displayed at the upper-right corner of the
screen.
Trigger Mode:
In the trigger control area (Trigger) on the front panel, press Mode to quickly switch
the current trigger mode. For details, refer to descriptions in "Trigger Mode".
Trigger Parameter Setting:
Set the trigger parameters (trigger holdoff and noise rejection) under this trigger
type. For details, refer to descriptions in "Trigger Holdoff" and "Noise
Rejection".
Delay Trigger
In Delay trigger, you need to set Source A and Source B. The oscilloscope triggers
when the time difference (△T) between the specified edges of Source A (Edge A) and
Source B (Edge B) meets the preset time limit, as shown in the figure below.
Note:
Edge A and Edge B must be two neighboring edges.
MSO8000 User Guide
LEVEL knob to adjust the corresponding trigger level.
LEVEL can quickly switch the
RIGOL
5-27
Advertisement
Table of Contents
