Chapter 2 Command System; Autoscale - Rigol DS4000E Series Programming Manual

Chapter 2 Command System

Chapter 2 Command System
This chapter introduces the syntax, function, parameters, and usage of each DS4000E command.
Contents in this chapter:

:AUToscale


:CLEar

:RUN

:STOP

:SINGle

:TFORce

:TLHAlf

:ACQuire Commands

:BUS<n> Commands

:CALCulate Commands

:CALibrate Commands

:CHANnel<n> Commands

:CURSor Commands

:DISPlay Commands

:EXT Commands

:FUNCtion Commands

IEEE 488.2 Common Commands

:LAN Commands

:MASK Commands

:MEASure Commands

:RECall Commands

:REFerence Commands

:SAVE Commands

:SYSTem Commands

:TIMebase Commands

:TRIGger Commands

:WAVeform Commands

Note:
1. Unless otherwise specified, the descriptions and parameter range in this manual all take DS4024E as
an example.
2. For the parameter setting command (time, frequency, amplitude, etc.), the digital oscilloscope can
only recognize the numbers, unable to recognize the unit sent together with them. The unit of the
parameter is a default one. For the default units of various parameters, refer to the descriptions for the
specified command.
:AUToscale
Syntax
:AUToscale
Description
Enables the waveform auto setting function. The oscilloscope will automatically adjust the parameters such
as vertical scale, horizontal time base, and trigger mode according to the input signal to realize an optimum
waveform display. This command functions the same as the AUTO key on the front panel
Remarks
When the waveform auto setting function is disabled (refer to the :SYSTem:AUToscale command), this

command is invalid.
DS4000E Programming Guide
RIGOL
.
2-1