To Set The System Language; To Connect The Probe - Rigol DHO900 Series Quick Start Manual

TIP
You can also click or tap
instrument powers on once connected to power.
5.4

To Set the System Language

This oscilloscope supports multiple languages. You can click or tap
Setup > Language to select the system language.
5.5

To Connect the Probe

RIGOL provides passive probes and logic probes (optional) for DHO900 series. For
specific probe models, refer to
information of the probes, please refer to the corresponding Probe User Guide.
Connect the Passive Probe
1. Connect the BNC terminal of the probe to an analog channel input terminal of the
oscilloscope on the front panel as shown in the figure below.
2. Connect the ground alligator clip or spring of the probe to the circuit ground
terminal, and then connect the probe tip to the circuit point to be tested.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
> Utility > Setup and set the "Power status" to "Switch on". The
DHO900 Data Sheet. For detailed technical
To Prepare for Use
> Utility >
15