Command System - Rigol MSO2000A Series Programming Manual

2 Command System

2 Command System
This chapter introduces the command subsystems of MSO2000A/DS2000A command set.
The topics of this chapter:
:AUToscale

:CLEar

:RUN

:STOP

:SINGle

:TFORce

:TLHAlf

IEEE 488.2 Common Commands

:ACQuire Commands

:BUS<n> Commands

:CALCulate Commands

:CALibrate Commands

:CHANnel<n> Commands

:CURSor Commands

:DISPlay Commands

:FUNCtion Commands

:LA Commands (MSO2000A/MSO2000A-S)

:LAN Commands

:MASK Commands

:MEASure Commands

:OUTPut<n> Commands (MSO2000A-S/DS2000A-S)

:RECall Commands

:REFerence Commands

:SAVE Commands

:SOURce<n> Commands (MSO2000A-S/DS2000A-S)

:SYSTem Commands

:TIMebase Commands

:TRACe<n> Commands (MSO2000A-S/DS2000A-S)

:TRIGger Commands

:WAVeform Commands

Note:
1. Unless otherwise noted, in this manual the introductions and parameter ranges are based on
MSO2302A-S.
2. For parameter setting commands (for example, the time, frequency and amplitude), the oscilloscope
can only accept numbers and set the parameters using the default units; it cannot recognize the
units sent with the parameters. For the default unit of each parameter, please refer to the description
in each command in the following introductions.
MSO2000A/DS2000A Programming Guide
RIGOL
2-1