Selective Call Alert Led; Over-The-Air Alias - Kenwood NEXEDGE NX-200 Function Reference

8 NXDN CONVENTIONAL SYSTEM
8.1 Initiating Voice Communications (Basic Transmission and Reception)
Configuration using KPG-111D/ DN
Configuring the Auto Reset Timer (

Selective Call Alert LED

Selective Call Alert LED is the function to make the LED blink orange when the transceiver receives a call using an NXDN
ID.
A user can notice by the LED that the transceiver is receiving a call.
Note
For NX-200S/ NX-300S, the blinking LED (orange) upon the receipt of a Selective Call indicates the following status of the transceiver.
(a) The transceiver has received a Selective Call (as a status of an incoming call history).
(b) The transceiver can respond to the transmitting transceiver by pressing the PTT switch.
Therefore, if the transceiver receives a Selective Call while the transceiver cannot respond to the transmitting transceiver; for instance,
the transceiver receives an ID inhibited to transmit, the LED blinks orange as the status (a). In this case, the transceiver cannot respond
even if the PTT switch is pressed.
Also, if LED for Auto Reset Timer is disabled and the time configured for Auto Reset Timer has elapsed, the matching status of
Optional Signaling will be reset. At this time, the LED indicating the status (a) continues blinking, so that the transceiver cannot
respond to the transmitting transceiver.
If the LED indicates the status (a), the LED will be turned Off by pressing any key. If the LED indicates the status (b), the LED will be
turned Off by pressing a key to which a specific functions is assigned. (Refer to
Configuration using KPG-111D/ DN
Configuring the Selective Call Alert LED (

Over-the-Air Alias

Over-the-Air Alias allows the receiving transceiver to display the ID Name of the transmitting transceiver when receiving a
call even if the ID Name of the transmitting transceiver is not configured for the receiving transceiver.
Using this function, Unit ID Name of the added unit does not need to be configured such as when a unit is added to the
system in service.
The transmitting transceiver sends Unit ID Name when making voice calls. If the receiving transceiver receives a call such
as an Individual Call, the Unit ID Name stored in the reception frame will appear on the main display.
Note
The received Unit ID Name appears after displaying differently from the received Unit ID Name in the following cases.
• The Unit ID of the transmitting transceiver is not configured in the Unit ID List.
• The Unit ID of the transmitting transceiver is not stored as Caller ID.
• The received Unit ID Name is different from the ID configured in the Unit ID List or the ID Name stored in the transceiver.
Configuration using KPG-111D/ DN
Configuring the Over-the-Air Alias to be enabled or disabled (
FUNC (K)/Ver 4.00
See FPRG 8.19.3 General 2 Tab)
See FPRG 8.19.4 Trunking Tab and 8.19.5 Conventional Tab)
See
Mode Reset Timer on page
FPRG 8.19.2 General 1 Tab)
CONTENTS
20.)
INDEX 111