Sidetone; Alert Tone; Minimum Volume; Tone Volume - Kenwood TK-2170 Series Function Reference

4.1.5

Sidetone

The transceiver emits this tone if a communication is
established or the transceiver finishes transmitting.
Table 4-6 Sidetone List
Function
This tone prevents the transceiver
on the receiving side from missing
calls in Conventional Group.
This tone can be used in conjunction
PTT Proceed Tone with the Proceed Tone Delay Time.
The transceiver emits this tone if the
transceiver establishes a connection
to the repeater by pressing the PTT
switch in Trunking System.
The transceiver emits this tone when
VOX Proceed Tone
transmitting with VOX.
The transceiver emits this tone when
PTT ID Sidetone
sending the FleetSync PTT ID.
The transceiver emits this tone when
Sidetone (DTMF)
sending DTMF codes.
The transceiver emits this tone when
Sidetone (2-tone)
sending 2-tone codes.
4.1.6

Alert Tone

The transceiver emits this tone when the transceiver
receives a call with DTMF, 2-tone or FleetSync.
Select 1 of 8 tones by using KPG-101D.
Table 4-7 Alert Tone List
Function
The transceiver emits this tone when
Alert Tone 1 to
the transceiver receives a call or
Alert Tone 8
message.
FUNC (K)/Ver. 1.01
Description
Description
Confidential
4.2

Minimum Volume

This function can be used to limit the minimum volume
level if the Volume control is turned to its lowest level.
With this function, a user can hear communication even if
the Volume control is unintentionally turned to its lowest
level. The volume does not change from the level heard
while the control is set to the most counterclockwise
position. The transceiver mutes completely if the Volume
control is turned to the most counterclockwise position
while Minimum Volume is not configured.
Configuration using KPG-101D
• Configuring the Minimum Volume (Refer to FPRG
6.7.1 Common Page 1 Tab - Minimum Volume.)
4.3

Tone Volume

This function can be used to configure the volume level of
various tones by using KPG-101D.
This function can be used to adjust the tone volume level
as appropriate for the operating environment.
Tone Volume can be configured for each tone by using
KPG-101D. The following Tone Volumes can be
configured.
Table 4-8 Available Tone Volume Settings
Tone Volume
The transceiver emits tones in conjunction
Current
with the volume level.
The transceiver emits tones with a fixed
1 to 31 tone volume. Larger values result in greater
volume.
Off The transceiver does not emit any tones.
Configuration using KPG-101D
• Configuring the Power-on Tone (Refer to FPRG
6.7.1 Common Page 1 Tab - Power-on Tone.)
• Configuring the Control Tone (Refer to FPRG
6.7.1 Common Page 1 Tab - Control Tone.)
• Configuring the Warning Tone (Refer to FPRG
6.7.1 Common Page 1 Tab - Warning Tone.)
• Configuring the Alert Tone (Refer to FPRG 6.7.1
Common Page 1 Tab - Alert Tone.)
• Configuring the Sidetone (Refer to FPRG 6.7.1
Common Page 1 Tab - Sidetone.)
• Configuring the Locator Tone (Refer to FPRG
6.7.1 Common Page 1 Tab - Locator Tone.)
4 SOUNDS
Operation
Contents Index
21