Power-On Tone; Control Tone - Kenwood NEXEDGE NX-200 Function Reference

6 SOUND
6.1 Tones that Sound When a User Operates the Transceiver or When the Transceiver Status Is Changed

Power-on Tone

A Power-on Tone sounds from the transceiver when the transceiver is turned ON.
Function
Power-on Tone A
Power-on Tone B
(Mobile only)

Control Tone

A Control Tone sounds when a function is activated by a user operating the transceiver.
Function
Key Beep A
Key Beep B
Key Beep C
Key-entry Error Tone
Rollover Tone
FUNC (K)/Ver 4.00
Tone
Call Fail Tone
Lone Worker Tone
Group-registration Invalid Tone
Call Processing Tone
Warning Tone
Network Failure Tone A
Network Failure Tone B
Man-down Pre-alert
Key Fail Alert Tone
Locator Tone Emergency Locator Tone
Proceed Tone
Sidetone VOX Proceed Tone
PTT ID Sidetone
Fixed Volume Key Tone
Volume Level Tone
Volume Key Tone
Alert Tone Special Alert Tone
Table 6-2 Power-on Tone
This tone sounds from the transceiver when the transceiver is turned ON.
This tone sounds when the transceiver is turned ON by pressing and holding the Power switch while
"Ignition and Switch" is configured for Ignition Sense Type. In this case, Timed Power-off is not activated.
Table 6-3 Control Tone
This tone sounds from the transceiver when a function is enabled by pressing a key.
This tone sounds from the transceiver when a function is disabled by pressing a key.
This tone sounds from the transceiver when data, such as DTMF Memory or a Test Mode adjustment
value, is written to the transceiver by pressing a key.
This tone sounds from the transceiver when the operation activated by pressing a key is denied.
This tone sounds from the transceiver if "Rollover" is configured for Rollover/ End Stop.
This tone sounds from the transceiver when the lowest zone number, the lowest channel, or GID number
is selected. (Refer to Rollover/ End Stop on page
Description and Type
Description
Description
28.)
CONTENTS INDEX 85