Aux Input Status Message (Mobile Only); (Mobile Only) - Kenwood NEXEDGE NX-200 Function Reference

12 FleetSync
12.6 Sending and Receiving a Status Message (Status Call)
Configuration using KPG-111D/ DN
Configuring the Emergency Status Response (

AUX Input Status Message (Mobile Only)

AUX Input Status Message can be used to send the specified Status Message when the AUX Input port goes high level to
low level or goes low level to high level.
The transceiver can send a Status Message when a sensor is attached to the AUX Input port and the status of the AUX
Input port changes. The transceiver sends the message to the FleetSync ID configured for Target Fleet/ID. (Refer to
Fleet/ ID on page 334.)
To use this function, AUX Input Status Message must be assigned to one of AUX Input ports.
Configuration using KPG-111D/ DN
• Configuring the AUX Input Status Message (
• Assigning functions to AUX Input (
AUX Output Status Message (Mobile Only)
AUX Output Status Message is the function to switch the status of the AUX Output port from high to low or from low to high
when the transceiver receives the specified Status Message. This function can be used to remotely turn the external
device On or Off.
To use this function, AUX Output Status Message must be assigned to one of AUX Output ports.
Configuration using KPG-111D/ DN
• Configuring the AUX Output Status Message (
• Assigning functions to AUX Output (
Storing the Selected or Sent Status (Status Hold)
Status Hold is the function to store in the transceiver the status selected from the Status List in Status Mode and the status
transmitted.
When the transceiver receives a status request message, the status stored in the transceiver will automatically be
transmitted. Also, the status stored in the transceiver will automatically be stored in GPS data and transmitted.
Configuration
Selected The transceiver stores the status selected from the Status List in Status Mode.
The transceiver stores the status selected from the Status List in Status Mode and the status transmitted by one of
the following method.
• The status transmitted when one of the AUX Input Status Message 1 to AUX Input Status Message 3 ports
Selected +
change (Mobile only)
Transmit
• The status transmitted when the transceiver is turned ON (Power-on Status)
• The status transmitted by pressing one of the Call 1 to Call 6 keys
• The status transmitted by using a PC command
Note
This function is unavailable for NX-200S/ NX-300S.
FUNC (K)/Ver 4.00
See FPRG 8.16.2 General 1 Tab)
See FPRG 8.16.7 Target Tab)
See FPRG 8.30.2 AUX Tab)
FPRG 8.16.7 Target Tab)
See
FPRG 8.30.2 AUX Tab)
See
Table 12-17 Status Hold
Description
CONTENTS INDEX
Target
335