Kenwood NEXEDGE NX-200 Function Reference page 163

8 NXDN CONVENTIONAL SYSTEM
8.5 Making an Individual Call
3
Enter a Unit ID.
Refer to Entering or Deleting a Code on page 48
methods.
 Using the PF keys
The characters can be selected by pressing the Up or Down
key (NX-200/ NX-210/ NX-300/ NX-410/ NX-411), or by
pressing the [ ] or [ ] key (Mobile), and the selected
characters can be determined by pressing the Menu ([
[*] key.
 Using the keypad
A Unit ID can be entered by pressing the [0] to [9] keys.
4
Press the PTT switch to initiate a Voice Call.
In order to initiate a Paging Call, the Side 2 key (NX-200/
NX-210/ NX-300/ NX-410/ NX-411) or the Square key (Mobile)
needs to be pressed.
In order to enter a Status Message or Short Message, the Menu
([ ]) or [*] key needs to be pressed. (Only if the transceiver
enters Individual Call Mode by a user pressing the Individual +
Status (NXDN) or Individual + SDM (NXDN) key or selecting
Individual + Status (NXDN) or Individual + SDM (NXDN) by a user
pressing the Menu key) (Refer to
Status Message (Status Call) on page
Note
If PTT Proceed Tone is enabled, a Proceed Tone sounds from the transceiver when the transceiver becomes ready for
communications after the PTT switch is pressed. (Refer to
Tone) on page 92.)
Configuration using KPG-111D/ DN
• Assigning functions to the PF keys on the transceiver (
• Configuring the Manual Dialing to be enabled or disabled (
• Configuring the Selcall on PTT (NXDN Conventional System) (
FUNC (K)/Ver 4.00
for entry
]) or
8.9 Sending and Receiving a
150.)
Using Sound to Notify the Timing to Start Communications (PTT Proceed
See
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
FPRG 8.12 Key Assignment Window)
See FPRG 8.19.2 General 1 Tab)
See FPRG 8.3.3 Page 1 Tab)
CONTENTS
Mobile
INDEX 129