Kenwood NEXEDGE NX-200 Function Reference page 269

9 NXDN TRUNKING SYSTEM
9.14 Communicating with a Telephone (Telephone Call)
3
Press the Side 1 key (Portable), the
A Disconnect Indication Tone sounds from the transceiver and
the communication will end.
Note
• The DTMF code can be sent during the call by pressing one of the [0] key to [9] keys, the [*] key or the [#] key.
• If Call Request Tone is enabled, a Call Request Tone sounds from the transceiver when the PTT switch is pressed to initiate a call
request. Also, if Call Processing Tone is enabled, a Call Processing Tone sounds from the transceiver while the PTT switch is pressed
and held after a call request is initiated by pressing the PTT switch. (Refer to
Been Initiated (Call Request Tone)/ Notifying the User with a Tone That a Call Request Is in Progress (Call Processing Tone) on page
212.)
• If PTT Proceed Tone is enabled, a Proceed Tone sounds from the transceiver when the transceiver becomes ready for
communications after the PTT switch is pressed. (Refer to
Tone) on page 92.)
• For Mobile, if the Mic On-hook Disconnect is enabled, a conversation ends by placing the microphone in the on-hook state.
• For details on the information displayed on the main display during transmission, refer to
Configuration using KPG-111D/ DN
Configuring the Selcall on PTT (
Receiving a Telephone Call
When the transceiver receives a Telephone Call, "PHONE CALL" appears.
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Note
• If Telephone Call Alert LED is enabled, the LED blinks orange when the transceiver receives a Telephone Call.
• If Telephone Call (Alert Tone) is enabled, a tone sounds from the speaker of the transceiver when the transceiver receives a Telephone
Call.
• The transceiver can respond to the transmitting transceiver by pressing the PTT switch, the Side 2 key (Portable), or the Square key
(Mobile) when the transceiver receives a Telephone Call. For Mobile, when Mic Off-hook Connect is enabled, the transceiver can also
respond to the transmitting transceiver by placing the microphone in the Off-hook state.
• When the transceiver receives a Telephone Call, the transceiver can reject an incoming call by pressing the Side 1 key (Portable), the
Triangle key (Mobile) or the [#] key.
Configuration using KPG-111D/ DN
• Configuring the Telephone Call Alert LED to be enabled or disabled (
• Configuring the Telephone Call (Alert Tone) (
FUNC (K)/Ver 4.00
Triangle key (Mobile), or the
Using Sound to Notify the Timing to Start Communications (PTT Proceed
See FPRG 8.9.6 Selcall on PTT)
FPRG 8.19.4 Trunking Tab)
See
[#] key.
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
Notifying the User with a Tone That a Call Request Has
 Display during transmission on page
Mobile
FPRG 8.19.4 Trunking Tab)
See
CONTENTS
207.
INDEX 235