Kenwood NEXEDGE NX-200 Function Reference page 348

12 FleetSync
12.4 Making a Selective Call
 If an ID is configured for the ID List and the ID Name is not
configured:
The list number appears.
 If an ID is not configured for the ID List (when the
transceiver receives an Individual Call or Group Call):
Fleet and ID appear.
 If an ID is not configured for the ID List (when the
transceiver receives a Fleet Call):
Fleet appears.
Individual Call/ Group Call
Pressing the PTT switch, the Side 2 key (Portable) or the Square key (Mobile) causes the transceiver to initiate a call to
the target transceiver shown on the main display.
The transceiver controls the mute only and does not enter Call Mode under the following conditions:
• The transceiver receives a call from a Fleet inhibited by the Interfleet configuration.
• The received ID is not registered in the Unit ID Encode Block.
• The ID has Transmit Inhibit enabled by selecting "Yes" in the Selcall List.
The LCD will restore to normal state by pressing a key on the transceiver. If Auto Reset Timer is configured, the LCD will
restore to normal state after the time configured for Auto Reset Timer elapses.
FUNC (K)/Ver 4.00
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
CONTENTS INDEX 314