Kenwood NEXEDGE NX-200 Function Reference page 545

APPENDIX
Available Functions for the PF Keys
Function Name
Broadcast
Battery Indicator
(NX-200S/ NX-300S)
Call 1 to Call 6
CH/GID Down
CH/GID Down (Continuous)
CH/GID Recall
CH/GID Up
CH/GID Up (Continuous)
Channel Entry
Clock
Clock Adjustment
CW Message
Direct CH/GID 1 to Direct
CH/GID 5
Direct CH/GID 1 Select to
Direct CH/GID 5 Select
Display Format
FUNC (K)/Ver 4.00
Alternates between Broadcast Call and Conference Call. This function
can be used only for initiating a Group Call. (Refer to
Informative Group Call (Broadcast Group Call) on page
The transceiver notifies a user by a lighting or blinking LED that the
remaining battery power is low. (Refer to
Battery Power Level (Battery Indicator) on page
Sends the signaling (Autodial List, 2-tone Encode List, Status List and
Unit ID List (NXDN)) configured for the transceiver.
Decreases the channel or GID number in steps of 1.
Pressing and holding the CH/GID Down key causes the channel or GID
number to be decreased in steps of 1 every 200 ms.
Pressing the CH/GID Recall key during the scan causes CH/GID Recall
to be toggled between enabled and disabled. If CH/GID Recall is
enabled, the transceiver will migrate to the channel or GID on which a
signal was last received. (Refer to
Increases the channel or GID number in steps of 1.
Pressing and holding the CH/GID Up key causes the channel or GID
number to be increased in steps of 1 every 200 ms.
Directly specify the channel number by pressing a key(s) on the keypad.
(Refer to Changing the Channel or GID by Specifying the Number
(Channel Entry) on page 29.)
Note
For NX-200S/ NX-300S, this function cannot be assigned.
The current time appears. (Refer to
TRANSCEIVER on page 500.)
Note
For NX-200S/ NX-300S, this function cannot be assigned.
The current time can be adjusted. (Refer to
ON THE TRANSCEIVER on page
Note
For NX-200S/ NX-300S, this function cannot be assigned.
Sends the CW Message configured for the transceiver. (Refer to
Communicating using a CW Message on page
Migrates to the channel or GID configured as Direct CH/GID. (Refer to
Direct CH/GID on page 35.)
Determines the displayed channel or GID as a Direct Channel or GID.
(Refer to Direct CH/GID on page
Toggles the display between the channel or GID name and Zone-channel
or GID number.
Note
For NX-200S/ NX-300S, this function cannot be assigned.
Description
9.9 Making an
228.)
7.1 Displaying the Remaining
105.)
CH/GID Recall on page 456.)
25 ADJUSTING THE TIME ON THE
25 ADJUSTING THE TIME
500.)
171.)
35.)
Available System
NXDN Trunking System
ALL
ALL
ALL
ALL
ALL
ALL
ALL
ALL
ALL
ALL
8.13
NXDN Conventional System
ALL
ALL
ALL
CONTENTS INDEX
*1
511